Cool as that was and is, it’s an acquired taste, so the new collection has a more mainstream three-link bracelet design. The 1960s model had a laddered design created by specialist Gay Frères, as seen on some of Zenith’s Chronomaster Revival models recently. One area of difference is the bracelet design. Despite the level of detail, and that its squeezed into a relatively small dial by modern chronograph standards, the read-out is fabulously well balanced and, dare I say it, far clearer than on the Chronomaster Sport. The inner of these still shows 100 segments, now used to break down the ten seconds it takes for the red hand to complete a full tour of the dial the outer, once a tachymeter, now shows the tenths of a second. Scratches can arise, but they are more likely to be deposits from the material that the case scratched against than a disappearance of the coating, so they can be buffed out at service, through sandblasting that will give a brand new finishing to the case.New to the design is how the two scales around the outside edge of the dial are used. So the vickers hardness of this material is lower than ceramic but it does not shatter on impact. Lightness is a pretty obvious characteristic, but another one I learned about was related to shocks and scratches, clearly something you never look forward to but which inevitably happens. Previously we'd only seen this in the El Primero Range-Rover Limited Edition, but now its going main line.Īnd, because you know my curiosity, I grilled the product development team on the advantages and drawbacks of such a case. Basically you can understand it as a fine ceramic coating over an aluminum base. Yet, the most modern feature is clearly the case material, a black ceramicised aluminum. The two new Zenith El Primero 36,000 vph (36,000 vibrations per hour being the beat rate of the caliber), are both the middle 42mm size.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |